Avenview SW-HDM3D-C5-8X8 Dokumentacja

Przeglądaj online lub pobierz Dokumentacja dla Switche sieciowe Avenview SW-HDM3D-C5-8X8. Avenview SW-HDM3D-C5-8X8 Specifications Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 20
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
www.avenview.com
1
8x8 HDMI Matrix Switch with 3D
over CAT-5 with IR Pass-Through
Model #: SW-HDM3D-C5-8X8
© 2009 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any
time without notice. No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in
Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products
Przeglądanie stron 0
1 2 3 4 5 6 ... 19 20

Podsumowanie treści

Strona 1

www.avenview.com 1 8x8 HDMI Matrix Switch with 3D over CAT-5 with IR Pass-Through Model #: SW-HDM3D-C5-8X8 © 2009 Avenview I

Strona 2 - Table of Contents

www.avenview.com 10 1.7.5 SW Main Dip Switch for Firmware Update DIP Switch Position PIN # 1 PIN # 2 PIN # 3 PIN # 4 Normal Operation Mode [via RS-

Strona 3 - Section 1: Getting Started

www.avenview.com 11 1.8 IR Control Patch IR Transmitter Cable IR Receiver Cable IR Main The default location for IR emitter extension cable

Strona 4 - 1.4 Introduction

www.avenview.com 12 1.9 Installation (SW-HDM3D-C5-8X8) To setup Avenview SW-HDM3D-C5-8X8 follow these steps for connecting to a device: 1. Connec

Strona 5

www.avenview.com 13 1.10 Operation and IR Control 1.10.1 Source Side 1.10.1.1Method A: Push Button 1. Use the “” or “—“ channel button on output p

Strona 6 - 1.6 Before Installation

www.avenview.com 14 1.10.2 Display Side 1.10.2.1Method A: Push Button Press the INPUT SELECT push button to switch the input source on the respective

Strona 7 - 1.7 Panel Description

www.avenview.com 15 1.11 RS232 Serial Port Control Scan: Press Scan button, the machine will scan the all com port and show them. Select the RS232

Strona 8

www.avenview.com 16 Linkage: Press Linkage button to read back all status Open / Close : Press this button to Close or Open COM Port. Mapping Button:

Strona 9

www.avenview.com 17 Group setting First select output ports one by one. Then select the input source. The selected output ports change the setting at

Strona 10

www.avenview.com 18 Section 2: Specifications Item Description Units SW-HDM3D-C5-8X8 HDM3D-C5SW-R Unit Description 8x8 HDMI Matrix Switch with 3D ove

Strona 11 - 1.8 IR Control Patch

www.avenview.com 19 Notice 1. If the DVI or HDMI device requires the EDID information, please use EDID Reader/Writer to retrieve an

Strona 12

www.avenview.com 2 including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any i

Strona 13

www.avenview.com 20 Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liabili

Strona 14

www.avenview.com 3 Section 1: Getting Started 1.1 Important Safeguards Please read all of these instructions carefully before you use the device. Sa

Strona 15

www.avenview.com 4 1.3 Regulatory Notices Federal Communications Commission (FCC) This equipment has been tested and found to comply with Part 15 o

Strona 16

www.avenview.com 5

Strona 17

www.avenview.com 6 - Silicon Image chipset embedded for best quality, compatibility and reliability - Support HDMI Deep Color & full 3D - HDCP

Strona 18 - Description

www.avenview.com 7 1.7 Panel Description 1.7.1 SW-HDM3D-C5-8X8 Front Panel 1. Power: Power Control 2. Seven Segment LED Indicators: LED display

Strona 19

www.avenview.com 8 1.7.3 HDM3D-C5SW-R 1. IR INPUT: Plug in IR receiver. 2. +5V DC: Spare power jack for over 60m transmission when the RX may n

Strona 20

www.avenview.com 9 1.7.4 Dip Switch for EDID & Audio Settings (SW1 – SW8) DIP Switch Position Video Audio Description PIN # 1 PIN # 2 OFF  OFF 

Komentarze do niniejszej Instrukcji

Brak uwag